I'm trying to fix a few naggling little problems on CT1272L, one of which is
a leaking valve cover. I have a fresh gasket to put on but as I was cleaning
the mating surface I noticed that lip of the valve cover is somewhat
inverted. This offers a very small area for gasket to contact. Is this
normal, or has mine been badly over torqued by the PO? TIA
--
Jerry McDonald: jmac@nwrain.com
"Religion and science are opposed...but only in the same sense as
that in which my thumb and forefinger are opposed--and between the
two, one can grasp everything." Sir William Bragg
|