Glenn Franco wrote:
>
> Jenny Parry wrote:
> >
> > Anyone know the trick required to grease the unviversal joints on a TR6
> > drive shaft? I cannot find anyway to get my greaseguns to fit over the
> > grease nipples!
> >
> > I have rebuilt my 1971 TR6 freom the frame up twice, (it was rear ended and
> > "totalled" by an idiot) but this job has proved impossible!
> >
> > Martin Parry
> ______________________
>
> Martin
>
> have you tried a grease nipple adaptor. They are available from most
> good auto parts stores. The end is shaped to a point and you don,t have
> to get the grease nipple over the grease fitting. The pointed end is
> placed on the check ball and pushed in.
>
> Glenn Franco
>
___________________________________________
Martin,
This device is called a "Grease Needle" and is available
at NAPA stores. Also I saw one at an "Auto Palace" parts
superstore, sold by a company called Plews, I think..
JOE IV
TR 250
WALLINGFORD, CT. USA
|