In a message dated 96-09-26 18:43:50 EDT, TRIPHSTEVE@aol.com writes:
>I am restoring a 1971 TR6 and trying to remember how to put things together.
>When the slave cylinder was replaced (hopefully, in the correct place) the
>bleed screw is touching the spin-on oil filter to the point it has dented it
>in the side. I had the original canister on the car before restoration and
>cannot imaging going through that again.
>
>Has anyone had the same problem? What is the remedy? Have I replaced the
>slave cylinder incorrectly?
Steve,
Loosen the bolt holding the spin-on filter adapter and rotate the adapter
forward a few degrees to clear the slave cylinder bleed screw. Thats what I
did.
Dave
St. Louis, MO USA
TR6Massey@aol.com
|