Mark,
If this is the piece of rubber that fits in the c channel along the
bottom of the door opening (near the threshold) I have the source for you.
Not all GT6's have this seal. My 71 does but later models did not have the
channel any longer. I looked for a long time for one myself and only
matched it up at a display TRF had at Sebring one year.
They had the same extrusion I had been wanting and asking them for for
years. Only they list it as the seal for a "Spitfire hard top to windshield
gasket". You will discover they are longer then you need but that is always
better that too short. You need to get two of these seals, one for each door.
I used a liberal amount of liquid soap on the channel and seal and slid it
in place. It helps to check the channel for dings and dents before this and
doing a little straightening as the fit is tight. I trimmed it off after it
was installed and had a chance to get relax back into shape after all the
tugging and pushing. Hope this helps,
Richard Ceraldi
71 GT6 MKIII KF166L
|