Hey All,
OK, I just have to build some shelving and a loft in the garage, and
then the rebuild will begin. T-minus one month.
As you all may remember I have to replace the rear trailing-arm
sections
with new units purchased from Rimmer Bros. My question is this, what
type of battle can I expect trying to get the old cross-members off the
frame. I have the Practical Classics book on doing a TR6 rebuild. They
talk about repairing section of the frame yourself. I would like to know
what other people's experience has been. Will a grinder, hammer and
chisel ne enough to do the job, or what.
Later,
JHD IV
|