>
>>>I'd like to confirm is this. On the inside there is ONE only tab. It is
>>>about 1/4" long and 1/8" wide siting on a mounting bracket of sorts. Is
>
>>Okay, there is supposed to be a little tab as you describe. This tab fits
>>into what looks like two half arrows sitting side by side. Not real easy
>>to get the tab in.
>> First, the headlight ring has to be hooked on the lip of the headlight
>>bucket at the top and then the tab inserted in the clip by pushing
>>straight in on the bottom of the ring.
>
>Yep, been there, done that AND ran over my NEW headlight ring the next day!
>
>Tony, you won't believe this will work, but after Bob Kramer (hctcbob@aol.com)
>quit laughing at the crushed brand new ring, he explained the correct method:
>
>"you shall place the tab into the arrows first, lift/push/clip"
>
>Too simple...
>
>Roger
Roger,
Now that I think about it, that does sound like it might be a better method.
However, I'm not going to rush out and pop a ring off just to try it.
I'll wait until I absolutely have to remove the darn thing first, then
I'll try lifting the top over the lip of the bucket.
Thanks for the tip.
Regards,
Tony
###
|