I tried what Will suggested years ago, and the throttle cable bracket
didn't line up with the throttle; it was off towards the center of the
engine by about an inch with the pin in the throttle cable pointing
outboard.. even more with it pointed in. This was with a Holly 6150 on an
Edelbrock manifold, but I checked the location on the original 2BBL
manifold, the mounts are in the same location and the 2BBL carb is the same
width as the 4BBl. (and the P/O had discarded the throttle cable and
bracket in favor of a piece of coat hanger so the original parts were long
gone.) So I fabricated a mount off the carb rear bolt for the replacement
throttle cable as a temporary fix until I could locate a bracket.
I'm inclined to think the bracket was included on the original manifold (as
one part number) as was previously suggested.
Tom
'67 Mark 2
On Mon, Jun 30, 2014 at 11:34 AM, wseay <wseay@embarqmail.com> wrote:
> B382001570 didn't come with one of these plates. I also have a copy of
> the installation instructions for the F4B factory high rise option. With
> regard to the throttle linkage bracket it says "Throttle linkage, bracket
> and return spring are installed in regular stock position. Make sure cable
> type throttle lines up correctly and you obtain full throttle with no
> binding, etc.". The instructions are careful to detail any adapters, etc.
> that are supplied for the installation. It's pretty clear to me that this
> plate didn't come as part of a factory high rise kit either.
>
>
> Will Seay - wseay@embarqmail.com
> ______________________________
> "I think not therefore I am not" (anon)
> -----Original Message----- From: Ron Fraser
> Sent: Sunday, June 29, 2014 12:00 PM
> To: tigers@autox.team.net
> Subject: [Tigers] Throttle bracket
>
> Before we were rudely interrupted last month, I was involved in a
> discussion about a triangle shaped plate that mounts to the stock intake
> manifold and should help with the alignment of the throttle cable to the
> carb.
>
> Gene Padgett first described this part. It is not listed in the Parts
> List. It is a stamped part made from 1/8" steel plate with 2 holes and a
> slot to adjust the position of the throttle cable bracket. I therefore
> believe it is an official Rootes part.
>
> Question:
>
> Do other Tiger owners have this plate under the throttle bracket?
>
> Ron Fraser
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/tigers/wseay@
> embarqmail.com
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/tigers/tkparker1941@
> gmail.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|