B382001570 didn't come with one of these plates. I also have a copy of the
installation instructions for the F4B factory high rise option. With regard
to the throttle linkage bracket it says "Throttle linkage, bracket and
return spring are installed in regular stock position. Make sure cable type
throttle lines up correctly and you obtain full throttle with no binding,
etc.". The instructions are careful to detail any adapters, etc. that are
supplied for the installation. It's pretty clear to me that this plate
didn't come as part of a factory high rise kit either.
Will Seay - wseay@embarqmail.com
______________________________
"I think not therefore I am not" (anon)
-----Original Message-----
From: Ron Fraser
Sent: Sunday, June 29, 2014 12:00 PM
To: tigers@autox.team.net
Subject: [Tigers] Throttle bracket
Before we were rudely interrupted last month, I was involved in a
discussion about a triangle shaped plate that mounts to the stock intake
manifold and should help with the alignment of the throttle cable to the
carb.
Gene Padgett first described this part. It is not listed in the Parts
List. It is a stamped part made from 1/8" steel plate with 2 holes and a
slot to adjust the position of the throttle cable bracket. I therefore
believe it is an official Rootes part.
Question:
Do other Tiger owners have this plate under the throttle bracket?
Ron Fraser
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/wseay@embarqmail.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|