could burn a valve especially if you are running lean
________________________________
From: Dave Munroe <dave@munroe.ca>
To:
"Smit, Theo" <Theo.Smit@dynastream.com>; tigers@autox.team.net
Sent:
Wednesday, August 21, 2013 1:03 PM
Subject: Re: [Tigers] Header bolts locking
strategies
In a word Theo, Yes. Must have had brain "lock". Shoulda
thought of that myself! Thanks for the boot.
My headers require that six of
these bolts (three on each side) have very small heads to clear the pipes.
Currently I have standard bolts in these locations that have the heads reduced
to take the open end of a 7/16" wrench. This is not a satisfactory solution as
you cannot get sufficient torque on them to keep them tight. Lock wire might
fix this. The rest of the bolts are ARP socket head manifold bolts. The walls
of the socket end of these bolts are too thin to reduce enough to fit by
grinding. What I need are socket head bolts that have a reduced head diameter
with the next size down Allen key. A strange bolt for sure, but I have not
been successful in finding such an animal on the WWW. Any ideas?
Also, is it
a bad idea to keep driving the car with a leak at the cyl.head/manifold joint?
Any danger of damaging the head or header surfaces?
Thanks for your help!
Dave
----- Original Message ----- From: "Smit, Theo"
<Theo.Smit@dynastream.com>
To: "Dave Munroe" <dave@munroe.ca>;
<tigers@autox.team.net>
Sent: Wednesday, August 21, 2013 1:10 PM
Can you
drill the bolt heads for lock wire?
Theo
>
> Hi Guys:
>
> I know on race
cars this is an ongoing problem and that bolt locks are
> usually fitted to
prevent this fault. But the headers I have leave
> little room for these
mechanical locks. Does anyone else have this
> problem, and is there a
reasonable solution that doesn't require engine
> removal to effect?
>
>
Perhaps a new set of headers? One of the many Loctite formulas that
> take
high heat?
>
> Help!
>
> dave
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/hunber@bellsouth.net
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|