Robert,
The rubber weather strip on my car is screwed to the drip molding from the
outside, and the drip molding is riveted to the windshield frame. I
probably have the old pictures on a cd somewhere, but they're not with me
in Florida; I remember it was somewhat confusing to figure out which were
rivet holes and which were screw holes; I think the rubber seals determined
which were which.
Tom
'67 Mark 2
On Mon, Aug 19, 2013 at 4:25 PM, Bates,Robert E Jr <RBATES@dental.ufl.edu>wrote:
> Hello - I am reassembling my 1966 Tiger after a full restoration, and am a
> little confused about the weather strip that is between the windshield drip
> molding and the door vent window. Is it just glued to the drip molding?
> How
> is it orientated? I'm sure it will be obvious once I'm done, but confusing
> now.
>
>
>
> Pictures of the installed weather strip would be appreciated. Please send
> to
> rbates@dental.ufl.
> edu>
>
>
>
> Thanks. Bob
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/tkparker1941@gmail.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|