Both front and rear lips are either trimmed or rolled on my car, per Tom
Hall's methodology :-)
In a message dated 2/2/2013 9:00:14 P.M. Pacific Standard Time,
genepadgett@comcast.net writes:
Correction to my initial response. On the rear I did trim the excess
inner well lip back at the top to the spot welds for additional clearance.
For the most part that just involved trimming off the amount of extra inner
fender well metal to the edge of the stock outer fender lip. A minor
adjustment in my view. No fender lip rolling involved.
Gene
To: MWood24020@aol.com
Cc: tigers@autox.team.net
Sent: Saturday, February 2, 2013 10:48:52 PM
Subject: Re: [Tigers] Thoughts on 7" front wheels
I personally like 15 inch wheels with 205/50 tires on 7 inch rims. That is
the setup I have for my "street tire class" autocross tires. They give a
very nice ride in conjunction with my 450 lb. front springs. My regular
street wheels are 16 inch wheels with 7 inch rims with 205/45 tires in the
front and 215/40 tires on the back. The result is a bit on the harsh ride
side.
The issue with 7 inch rims on the front is to have the correct backspace.
You need a backspace of 4.75 inches to get the wheel and tire to fit
reasonably well inside or equal to the outer fender line and still have the
wheel
clear the suspension control arms at full deflection. Given the width of
the 205 tire, you will have to trim off about 1/4 inch of the lower edge of
the front valence where it curves back a bit toward the wheel opening for
clearance at full steering lock. Many people have done that and the trimming
is really not noticeable to any significant degree. I did not have to do
any other wheel well or fender lip modification.
While you are not predisposed to 6 inch rims and narrower tires on the
front, keep in mind wider front tires result in a noticeably heavier steering
effort especially at low speed.
Gene
----- Original Message -----
From: MWood24020@aol.com
To: tigers@autox.team.net
Sent: Saturday, February 2, 2013 8:33:04 PM
Subject: [Tigers] Thoughts on 7" front wheels
I'm about to buy some new wheels for my Tiger. Because of the lack of
quality off the shelf wheels for our cars, I'm leaning towards 15"
diameter
Panasports. While kind of "belly button" wheels, they are very well made
and
reasonable cost.
The usual 6" front/7" rear fitment has limited appeal, primarily because
of the handling compromises that result. I'd like to run 7' all around
with
equal size tires.
Anyone have direct experience with the 7's and clearances? My valence is
near stock, we did do some basic smoothing, prior to the car going to
paint.
How large a tire might fit? (I could see running as small as 195/50-15 at
all four corners).
Thanks for any thoughts!
Mike Wood
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/genepadgett@comcast.net
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/genepadgett@comcast.net
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|