Graham
These parts are listed in the Alpine Parts list; Section X Body
Mountings.
http://www.tigersunited.com/resources/factory_parts_list/Alpine/alpine_part_
list.asp
4 fasteners are listed for the lower finisher but the drawing for the
fastener does not help. This is where pictures of original fasteners would
be helpful to us all.
I used a clip of some sort with a threaded stud. I did find some
clips in my parts collection that maybe what I used. It is a stock clip
with a wire wing ding that would be removed. The top plate is .33" wide,
3/4" long with a 10x24 stud. Possibly Auveco # 2744; Auveco has an online
catalog maybe you can still find them or something that will fit.
My Tiger is not in a position to get at those fasteners right now.
Hopefully someone on the list can give you the hole locations.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Graham Harlowe
Sent: Saturday, October 09, 2010 10:47 AM
To: tigers@autox.team.net
Subject: [Tigers] Lower Grill Finisher Fasteners
All -
I'll be installing the lower grill finisher soon. (This is the stainless
trim that fastens to the top of front valance.) My front valance has been
replaced and I don't recall how many fasteners were used to attach this
piece, nor their locations. Can anyone provide an estimate for how many
fasteners were used and approximately where along the piece they were
located (i.e. where to drill the holes in the valance)? Also, any
recommendations what to use as fasteners to attach/retain this piece?
Thanks much, as always...
Cheers,
Graham Harlowe
B382001466
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|