Hi. The problem is that another lister has a pulley for me but is not sure
it's the right one. So the only way to know is trial and error? I was
hoping there would be a part number to be able to verify before shipping and
trying it out... Anyone? I tried to measure the one in my stock Tiger with
the engine still installed, and it seemed more like 7 inches, but this is
probably wrong because it was nearly impossible to get to. Thanks. Mauro
On 1/31/10 5:20 PM, "Theo Smit" <tsmit@shaw.ca> wrote:
> MAURO D'ANGELO wrote:
>> All, I need the part number of the Tiger pulleys, mainly the lower one by
>> the balancer. We're trying to figure out if the one we have is from a Tiger
>> or some other car. The part has a number C40E and under that is A1. Does
>> this sound like it is the right one? Thanks. Mauro
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> You are subscribed as tsmit@shaw.ca
>>
>> Tigers@autox.team.net
>> http://autox.team.net/mailman/listinfo/tigers
>>
>> http://www.team.net/archive
>>
>>
> You'll know if it's right, by how close it comes to wiping out the
> steering rack tube. It should only have one sheave, and about 1" offset
> from the balancer flange to the center of the sheave. Its outer diameter
> is about 5.5 or 6 inches. Most other Ford pulleys have a deeper offset
> and they won't leave enough clearance between the rack tube and the
> pulley. The correct one allows you to remove the water pump belt without
> having to crush it (too much) between the rack and the pulley.
>
> Theo
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|