Interesting. Folks, the wonderful world of cut and paste into a plain
text editor seemed to have replaced the "degree" symbol with a zero. Not
kewl.
Here is what they should be. Also, I misspelled one term, glycol-based
brake fluid is hyGroscopic. Too early on a Monday.
Brake Fluid Rating Dry boiling point Wet boiling
point
DOT 3 205C (401F) 140C (284F)
DOT 4 230C (446F) 155C (311F)
DOT 5 260C (500F) 180C (356F)
DOT 5.1 270C (518F) 191C (376F)
And as for you Dr. Mayf, tungsten doesn't melt until over 3420C (3693K),
so there!
Here is a chart just for you:
Brake Fluid Rating Dry boiling point Wet boiling
point
DOT 3 478K 413K
DOT 4 503K 428K
DOT 5 533K 453K
DOT 5.1 543K
464K
Bugz
-----Original Message-----
From: drmayf [mailto:drmayf@mayfco.com]
Sent: Monday, June 15, 2009 10:01 AM
To: Rense, Mark (GE Indust, ConsInd)
Cc: tigers@autox.team.net
Subject: Re: [Tigers] brake fluid - Types
Bugz... did you miss some decimal points in the boiling points table
below? Hard for me to believe those temperatures. I mean DOT 5.1 boils
at 5180 degrees F? And so on...
I think that may be higher than melting tungsten or other exotic metal
alloys...
mayf, just funning ya
Rense, Mark (GE Indust, ConsInd) wrote:
>The main difference between DOT 3 and DOT 4 (both glycol-based) is the
>boiling point. The DOT 4 has a higher boiling point for both wet and
dry measurements.
>This is important to us because our clutch and master cylinder
>reservoirs are not sealed and therefore allow the passage of moisture,
>and since glycol-based fluid is hydroscopic, the DOT 4 rating will
>allow more moisture content while still providing adequate service.
>
>You CANNOT mix DOT 3 or 4 with DOT 5, as DOT 5 is silicon based.
>However, you can mix with the new DOT 5.1 fluid. The recommended fluid
>for most British cars old and new is Castrol GT/LMA, which is rated as
>a DOT 3/4. If you rebuild your hydraulics with all new synthetic rubber
>parts, you can use the silicon-based DOT 5, the advantage here is that
>when (notice I didn't say
>"if") it leaks, it does not affect the paint. The disadvantage of DOT 5
>is that it does not absorb water at all, so the water pools in the
>cylinders and causes corrosion.
>
>In any case, flushing your brake fluid every other year is a Best
Practice.
>
>Brake Fluid Rating Dry boiling point Wet boiling
point
>DOT 3 2050C (4010F) 1400C (2840F)
>DOT 4 2300C (4460F) 1550C (3110F)
>DOT 5 2600C (5000F) 1800C (3560F)
>DOT 5.1 2700C (5180F) 1910C ( 3760F)
>
>Bugz
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|