Thanks to everyone who responded. I had the same problem that Tony had
previously. I found the reference to the TigersUnited link in the
archives, but could not get it to work. Now I have it. Thanks!
-Randy
Steve Laifman wrote:
> Randy,
>
> Well. not ALL the archives ;-)
>
> There are some excellent pictures of the Ford Motorsport right
> angle filter assembly including all the mounting hardware that comes
> with it from Ford. Note slight "file rounding" of motor mount corner
> for clearance from sharp edge.
> *
>
>http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter3.asp*
>
> This is the unit I have, and the Ford Motorsport FL1A filter
> (recommended) fits fine. The smaller diameter FRAM is not required,
> but an oil filter body clamp is easy to use. Don't over-tighten, as
> it distorts the sealing surfaces.
>
> Check Ford distributer parts department.
>
> Steve
> ___
> Steve Laifman
> Editor - TigersUnited.com
>
>
>
> Randy Smith wrote:
>> This is a very old discussion, but I /*searched the archives*/ and did not
>> find this one bit of information. I have a Ford Motorsports right angle
>> oil filter adapter that I'm about to install. I need the stock oil
>> filter nipple that screws into the block since the stock Tiger setup
>> eliminates that and the FMS adapter does not come with it. Does anyone
>> know the Ford part number for the nipple? My local Ford parts guy does
>> better with a part number. He's barely old enough to know what a small
>> block is! Any help would be appreciated.
>>
>> Thanks- Randy
>>
--
Randy Smith
INNER QUEST, Inc.
34752 Charles Town Pike
Purcellville, VA 20132
703-478-1078
540-668-6699
540-668-6253 fax
InnerQuestOnline.com <http://www.innerquestonline.com/>
RSSmithIQ@cs.com
Tiger- B382000189
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|