Randy,
Well. not ALL the archives ;-)
There are some excellent pictures of the Ford Motorsport right angle
filter assembly including all the mounting hardware that comes with it
from Ford. Note slight "file rounding" of motor mount corner for
clearance from sharp edge.
*
http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter3.asp*
This is the unit I have, and the Ford Motorsport FL1A filter
(recommended) fits fine. The smaller diameter FRAM is not required, but
an oil filter body clamp is easy to use. Don't over-tighten, as it
distorts the sealing surfaces.
Check Ford distributer parts department.
Steve
___
Steve Laifman
Editor - TigersUnited.com
Randy Smith wrote:
> This is a very old discussion, but I /*searched the archives*/ and did not
> find this one bit of information. I have a Ford Motorsports right angle
> oil filter adapter that I'm about to install. I need the stock oil
> filter nipple that screws into the block since the stock Tiger setup
> eliminates that and the FMS adapter does not come with it. Does anyone
> know the Ford part number for the nipple? My local Ford parts guy does
> better with a part number. He's barely old enough to know what a small
> block is! Any help would be appreciated.
>
> Thanks- Randy
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|