tigers
[Top] [All Lists]

Re: [Tigers] Llooking at a car/restoration and parts $$$..... Part

To: <AAAGLASSS@aol.com>, <tigers@autox.team.net>
Subject: Re: [Tigers] Llooking at a car/restoration and parts $$$..... Part
From: "Smit, Theo" <Theo.Smit@dynastream.com>
Date: Tue, 3 Jun 2008 07:38:56 -0600
Any competent driveshaft shop can change the length of a driveshaft or
build you one from scratch. However, since the spline size and output
shaft diameters of the Ford T-5 and the toploader are the same, you can
use the original driveshaft. I think the T5 tailhousing and shaft are a
little shorter than the toploader, so the spline engagement isn't quite
as good with the T5 as it is with the toploader if you use the original
driveshaft.

Theo

-----Original Message-----
From: tigers-bounces+theo.smit=dynastream.com@autox.team.net
[mailto:tigers-bounces+theo.smit=dynastream.com@autox.team.net] On
Behalf Of AAAGLASSS@aol.com
Sent: June 2, 2008 5:46 PM
To: cmccann@lwpb.com; tigers@autox.team.net
Subject: Re: [Tigers] Llooking at a car/restoration and parts $$$.....
Part 2 of 2

Can the stock drive shaft and the drive shaft for the 5 speed be spliced
to accommodate this or is it not the correct thing to do??
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>