I'm resending this from last week in two parts, I think the message
length was too long before and it didn't go through, maybe this will
work...
Steve,
In regards to the costs and effort associated with fixing or restoring
these items, I'm sure most of the listers would point you towards the
Tigers United tech link on dash restoration:
http://www.tigersunited.com/techtips/ParlantiDash/rt-ParlantiDash1.asp
I have read this article and have started my dash restoration using it
as a guideline. In my opinion, the thing to consider most about dash
restoration is are you going to go back to the burl walnut on plywood
veneer or just use a solid walnut plank as often occurs. I personally
love the burl walnut, and there are a few places, especially online,
that will sell high quality burl walnut veneer. I purchased my veneer
from Constantines just like the article refers and it works great so
far. The hardest part was finding the right piece of plywood for the
substrate. Different grades of plywood will have different qualities and
finished thicknesses....IN SHORT, the veneer is about 140 bucks plus
shipping...unfortunately you must buy the 24 x 48" size which will fit
the 48" distance for the dash, but, you will have some left over. I
think you can buy a dash completed from Rick at Sunbeam
Specialties...see continued next email....
Steve wrote:
"......Is there anyplace on the net that I can find prices either firm
or approximate for
parts or restoration or repair. For example I know the car I'm going to
see has a lousy wood dash. How much to replace or refinish ? How much to
rebuild a Ford V8 ? How much to replace a stock carb ? How much to
replace clutch or transmission ? It would be very helpful to have a
better feel than I now have for what various defects will cost.
Thanks in advance
Steve........."
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|