You may find it even easier if you rotate the crankshaft instead. ;-)
-----Original Message-----
From: owner-tigers@autox.team.net [mailto:owner-tigers@autox.team.net] On
Behalf Of Dick Barker
Sent: Saturday, September 02, 2006 6:55 PM
To: mmichels@socal.rr.com
Cc: tigers@autox.team.net
Subject: Re: Valve cover bolt
Mike Michels wrote:
"The left side cast valve cover won't come out without dropping the rear of
the powertrain (I'm guessing the stamped steel covers do not have this
problem)"
Mike
You may not have to drop the powertrain. Try rotating the engine until both
rocker arms on the #8 cylinder are depressed (both valves fully open.)
Dick
|