Of course, Frank.
This is not a do-it-yourself project, but one that requires the
appropriate tools and a Churchill Press, etc.. All of these details are
specified in the Workshop Manual that is on our site. This is a job for
a pro, not a do-it yourselfer. As such, a 4 WD shop, or similar, has
all the standard equipment (in their business) to remove and replace
this. No physical modifications are required, and the job is no
different than changing rear end gears. Lots of Tiger owners do just
that. (and many suffer the consequences)
Since the R&R Differential instructions are in the on-site Workshop
Manual, all I did was inform the seeker of an even better choice than
cutting down some other car's rear end (which is no small chore). Since
that was HIS alternative, I think the one recommended is better,
especially since you can keep your current R&P.
There are, of course, those who would try this job with some crow bars,
and the result will be a disaster. If you do not know what jobs are
within your skills, you should not be attempting them.
I believe the information, in the right hands, is useful.
Steve
itswonderful@comcast.net wrote:
> Steve,
>
> Sure they "bolt right in" after you have spent the several hours to
> get all the shims right and suiff. And sure the ring gear bolts right
> to the posi unit. When most people think "bolt right in" they take
> it literally. You can not open a box and bolt one of these units
> right in to your existing Tiger rear end with everyday hand tools as
> you are well aware. you need micrometers, shims, presses, case
> spreaders (although you can do without this), and know how.
>
> Frank
>
>
--
-----
Steve Laifman
Editor
http://www.TigersUnited.com
--
-----
Steve Laifman
Editor
http://www.TigersUnited.com
|