Mark,
Thanks for posting your site. I've finally managed to relocate my
"patina" picture!
Another way to take care of the dual point issue is to replace it
with a Pertronix unit. Didn't effect my tach, but then mine's a SW.
Roland
On Mon, 15 Dec 2003 09:24:01 -0800 "Olson, Mark W"
<mark.w.olson@intel.com> writes:
> Bob,
>
> SNIP
> in the case above the calibration pot. Check out my tech tip at
> http://www.classictiger.com/techtips/motach.html to see advice on
> taking
> the tach apart for calibration
>
> The best way to ensure the dual points are set properly is to use a
> scope, probably best checked on a dyno at various RPMs.
>
> Mark
|