Steve,
Accel is now part of Mr Gasket. You can download the instructions for your
distributor from their site. I don't know the model you have, but you can
check them for yourself at
http://www.mrgasket.com/accel.htm
For example, if your distributor is a 71000 series, then the PDF
instructions are at
http://www.mrgasket.com/accelpdf/71000Dist.pdf
I note in these instructions that the coil resistance must be less than 1
Ohm and you also must bypass any ballast resistor. You can back up to
http://www.mrgasket.com/
And check out their other complete offering of products and services.
Brgds,
Bob
At 07:29 PM 6/4/00 -0400, Steve Griffing wrote:
>I have an Accel breakerless distributor that uses a GM ignition module.
>
>Q: Does the 'B' stand for battery (The switch) and 'C' the coil?
>
>I bought it used so there is no wiring diagram.
>I guess it's time to pull out those dusty Motors manuals again.
>As usual, any help is greatly appreciated.
>
>"Brake late, slide the rear"
>Steve, aka-bartdog
|