Brad, and Listers,
In my opinion it's easier to remove a weld than it is to fill in a drillhole in
sheetmetal. One issue with weld-in installation is that you can't paint the bar
easily, but a weld-in roll bar is lighter than the equivalent bolt-in
installation by about ten pounds, and you have more flexibility in terms of
locating the hoop mount plates because you don't need to be able to get at the
backside.
Theo Smit
tsmit@novatel.ca
B382002705
> -----Original Message-----
> From: Brad Joern [SMTP:bjoern@purdue.edu]
> Sent: Friday, May 21, 1999 11:53 AM
> To: Theo Smit
> Cc: tigers@autox.team.net
> Subject: Re: Roll Bar and Questions
>
> Theo,
>
> Thanks for the info. That sounds like this rollbar would need to be welded in
> because a backing plate would be nearly impossible if my memory of the rusty
> car
> bottom is at all clear. That is no big deal, but the ability to remove it
> would be
> pretty much lost.
[] <snip>
> Brad C. Joern
> Associate Professor,
> Soil Chemistry/Plant Nutrition
> Department of Agronomy
> 1150 Lilly Hall of Life Sciences
> Purdue University
> West Lafayette, IN 47907-1150
> TEL:(765)494-9767
> FAX:(765)496-2926
> E-mail:bjoern@purdue.edu
>
|