I took the "two gasket" route and it works fine
Lou
----------
> From: Doug Mallory <rdmallory@earthling.net>
> To: BlueGolfer@aol.com
> Cc: tigers@autox.team.net
> Subject: Re: Roller rocker and valve cover clearance
> Date: Tuesday, November 03, 1998 11:12 AM
>
> Grind them out...
>
> I have the same setup with no problem. You can run two gaskets glued
together
> but I did not want to take that route.
>
> Doug
>
> BlueGolfer@aol.com wrote:
>
> > Darn, I just had aluminum roller rockers installed on my motor. I now
find
> > that they are taller than the stock rockers and interfere with the
baffles
> > inside the cast aluminum Sunbeam Tiger Powered by Ford valve covers.
Has
> > anyone else run into this problem and what did you do?
> >
> > I'm concerned that removing the baffles will spray oil out the holes in
the
> > valve covers. Perhaps there is a spacer one can buy to raise the valve
cover?
> >
> > Rob Kempinski
> > Baffled in Florida
>
|