I pulled the steering column. Two bolts in car and two under hood. And
unplug a few wires.
Doug
-----Original Message-----
From: Curt Cacioppo <ccaciopp@haverford.edu>
To: tigers@autox.team.net <tigers@autox.team.net>
Date: Monday, October 12, 1998 7:49 PM
>I have recently repaired my master& slave clutch cylinders. Everything has
>gone smoothly, and I'm reasonably hopeful that this may be the fix. Only
>thing is, I can't seem to get one of the bolts that holds the slave to
>the bulkhead through its hole. This is the one further from the center
>point of the car, which is so close to the floor board wall that goes
>around the exhaust pipe that you can't really get in there with tools or
>even your fingers to push it through or thread the nut onto it. Any tips
>on how I can successfully finish attaching this little monkey? I've been
>deprive dof beaming for too long!
>
>
>
|