I have recently repaired my master& slave clutch cylinders. Everything has
gone smoothly, and I'm reasonably hopeful that this may be the fix. Only
thing is, I can't seem to get one of the bolts that holds the slave to
the bulkhead through its hole. This is the one further from the center
point of the car, which is so close to the floor board wall that goes
around the exhaust pipe that you can't really get in there with tools or
even your fingers to push it through or thread the nut onto it. Any tips
on how I can successfully finish attaching this little monkey? I've been
deprive dof beaming for too long!
|