tigers
[Top] [All Lists]

Re: Crossmember Bolt Tech Tip

To: Carmods@aol.com
Subject: Re: Crossmember Bolt Tech Tip
From: Frank Marrone <marrone@wco.com>
Date: Thu, 12 Feb 1998 08:21:41 -0800
This is what I figure is needed,

2ea     1 5/8" grip, 4 3/4" total length,  1/2"DIA X 20TPI

2ea  1 5/8" grip, 5 1/2" total length,  1/2"DIA X 20TPI


The grip is same as stock, the length is not.  These specs should yield a
bolt that sticks a little more than 3/4" out of the top of the hole using
the stock thick flat washers plus a SAE type locking washer on the bottom
side.  I tried to be pretty careful with my measurements but if anybody
knows that these are not the correct specs please let me know!


At 09:26 AM 2/12/98 EST, you wrote:
>Frank; 
>If you would give me the dimensions of the bolts that should be used I  could
>look around Detroit. I've almost always been able to find most of the unusual
>attaching hardware that I need. I won't find any Wentworth however, if that's
>what they are, so maybe that should be checked out.
>If it's a good idea, maybe others are interested.          
>                                                               John Logan
>
>
Frank Marrone           MK I Tiger B9471116
marrone@wco.com         '97 Crown Vic LX        
                        Yamaha Seca 900 (aka XJ900RK)
                        '79 Spitfire
                        '66 Ford LTD
                        '88 Nissan 4WD p'up


<Prev in Thread] Current Thread [Next in Thread>