At 10:00 AM 9/9/97 -0400, you wrote:
>In a message dated 97-09-09 02:49:57 EDT, anitabrt@mindspring.com (Anita
>Barrett) writes:
>
><< out of my eye as a result. ( This was with safty glasses and goggles
>too.)
> I drilled the steam holes in the block to match the 351W head gaskets
> as was recommended at that time. I used the original 289 head bolts with no
> problem.
> I di >>
>Do these 'steam' holes correspond with the lozenge shaped holes on the intake
>side of the head? Are they the equivalent of the small hole just over the
>bore in the 289-302 block?
>Ray
Small 1/8" holes similar to the 289 steam holes. Locate holes locations with
new 351W head gasket as the templet.
Jim Barrett Tiger II 351C and others
>
|