My headers (350hp, 302) are Jet-Hot coated. They are extremely hot. =
Adjusting the idles mixture on the drivers side right after driving
requires gloves (I've already singed the hair off the back of my hand).
I am getting ready to wrap my headers. Since I have no intentention of
pulling the engine just to pull the headers (Yea Jim, I know, you've got
room to manuver so you didn't have to pull the motor) I'm going to try
Thermo-Tec's new sleeve material. It's the same stuff that the wrap is
made from but it comes in 22" by 6" (or so) wide sheets with fasteners ev=
er
couple of inches. Wiggle it down along side the tubes, wrap it around th=
em
and snap them shut. I'll let you know if it works.
Regards,
Jim
B9470139
|