Re: [Spridgets] Axle issue

["Nelson Wittstock" <k8djc@zoominternet.net>]

I just recently went through the same thing.  I lost track of how many times 
it moved back and forth but just a little bit.  Being able to knock it out 
from the inside of the diff was a major challenge.  None of my punches were 
able to reach through to the broken off piece.  Finally I found a small 
diameter rat tail file that would make contact with the axle piece.  I just 
kept beating the piece out a little and then back in.  Then all of a sudden 
it was laying on the floor.  In the process about an inch of the file broke 
off but at that point it was worth losing it.  I gave a lot of thought to 
just giving up but then what would I do.  All I can say is just keep doing 
what you have been doing and I wish you luck.

Nelson 
------------------------

spridgets@autox.team.net


Archive: http://www.team.net/archive