I tried to use the hardware store nylon washers when I assembled mine but
they were just a bit too thick to get two in there. I ended up using some
small pieces of felt. Will see how they last when this thing eventually gets
on the road.
Duncan
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Woerpel
Sent: Friday, August 21, 2009 5:11 PM
To: Spridgets
Subject: Re: [Spridgets] Hand brake cable
Dave,
Yes I have. Piece of cake, or leather. Fairly thin pieces as you need
2/side. Rubber or nylon washers might work as well but leather was used
to help retain a SMALL amount of oil (I use silicone spray.).
Dave W.
David Lieb wrote:
>> There are universal brake cable adjusters, if you have room. Take a
picture
>> of this into your FLAPS. Bill in Oregon
>>
>
> Speaking of handbrakes, I am getting tired of the jingle behind me
> from the e-brake rods. Anyone made replacement leather washers for the
> pins? Anything else to make them from?
> David L
You are subscribed as duncan@pondhop.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|