To quiet down those bars I slit two pieces of 1/4" OD Tygon tubing about 14"
long each, wrapped one around each bar and zip-tied them in-place. Knocked the
noise down some and made Tygon versions of the leather spacers. Pretty well
cut the noise out.
BillM
> Date: Fri, 21 Aug 2009 17:10:38 -0500
> From: dwoerpel@wi.net
> To: spridgets@autox.team.net
> Subject: Re: [Spridgets] Hand brake cable
>
> Dave,
>
> Yes I have. Piece of cake, or leather. Fairly thin pieces as you need
> 2/side. Rubber or nylon washers might work as well but leather was used
> to help retain a SMALL amount of oil (I use silicone spray.).
>
> Dave W.
>
>
>
> David Lieb wrote:
> >> There are universal brake cable adjusters, if you have room. Take a
picture
> >> of this into your FLAPS. Bill in Oregon
> >>
> >
> > Speaking of handbrakes, I am getting tired of the jingle behind me
> > from the e-brake rods. Anyone made replacement leather washers for the
> > pins? Anything else to make them from?
> > David L
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as billmasq@hotmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_________________________________________________________________
Get back to school stuff for them and cashback for you.
http://www.bing.com/cashback?form=MSHYCB&publ=WLHMTAG&crea=TEXT_MSHYCB_BackTo
School_Cashback_BTSCashback_1x1
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|