I'm using a both shims and the standard rocker springs.
I pickup up some polished washer type shims to accurately locate each rocker
over the top of each valve (you still want them a little off-center). I don't
remember where I got them (probably Mini-mania at the time), but I'm sure you
can find them elsewhere, or simply make your own.
Regards,
Bryan Vandiver
'59 bugeye - 1275
San Jose, CA
--- On Thu, 12/11/08, Hal Faulkner <hal@katemuir.com> wrote:
From: Hal Faulkner <hal@katemuir.com>
Subject: [Spridgets] Rockers: springs or spacers?
To: "Spridgets" <spridgets@autox.team.net>
Date: Thursday, December 11, 2008, 9:23 AM
Spridgeteers,
Continuing my long-term motor build, I am checking the fit of my hi-lift
rockers. What is the consensus on using springs versus rigid spacers to
hold the rockers in position on the shaft? Vizard actually reccommends
springs, but I'm wondering what the collective wisdom of the list is.
Hal
You are subscribed as bvsprite@yahoo.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|