I am running hi lift roller rockers. I decided on rigid spacers, because I
could more accurately locate the roller tip over the valve stem.
David Riker
----- Original Message -----
From: "Hal Faulkner" <hal@katemuir.com>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Thursday, December 11, 2008 9:23 AM
Subject: [Spridgets] Rockers: springs or spacers?
> Spridgeteers,
> Continuing my long-term motor build, I am checking the fit of my hi-lift
> rockers. What is the consensus on using springs versus rigid spacers to
> hold the rockers in position on the shaft? Vizard actually reccommends
> springs, but I'm wondering what the collective wisdom of the list is.
> Hal
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as davriker@nwi.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.16/1843 - Release Date: 12/11/2008
8:36 AM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|