Thanks one and all.. looks like there are a few more spots to hit
and unless a better idea comes up, that I may have to disassemble the
A arms and find a way to get another zerk fitting toward the back. I
mean I when I put this puppy together I cleaned the inside of those
pins and the grease grooves but I'm not convinced that the grease is
going anywhere other than out that first cork "seal".
Lester
On Oct 6, 2008, at 3:52 PM, cclabaw@juno.com wrote:
> There's also a grease nipple on the handbrake cable.
>
> Clay L.
>
>
>
> -- Lester <oldsaabguy@comcast.net> wrote:
> Ok, it's that time of year so I am under the Bugeye for it's first-
> since-assembly lubrication and I find:
>
> One grease nipple on the outer tie rod
>
> One grease nipple on the lower fulcrum
>
> One upper and one lower on the suspension king pin.
>
> First question is what am I missing?
>
> Second is as I watch grease squirt out of only the front half of the
> fulcrum (between the A arm and kingpin mount) do I understand that to
> mean that I have to disassemble the entire thing again to figure out
> why the grease won't go past the kingpin?
>
> Thanks as always,
>
> Lester
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as cclabaw@juno.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
>
>
> ____________________________________________________________
> Career Problems? Get a Fashion Design Education. Click Now.
> http://thirdpartyoffers.juno.com/TGL2141/fc/
> Ioyw6i3oIaxuu9UZxvHweCFkEcBEjLJ4OgYlqICUbcIYsp2yJYr8Td/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|