spridgets
[Top] [All Lists]

Re: [Spridgets] Removing a cut-off bolt.... Ideas??

To: <spridgets@autox.team.net>
Subject: Re: [Spridgets] Removing a cut-off bolt.... Ideas??
From: <corvallis@peoplepc.com>
Date: Sat, 28 Jun 2008 12:28:30 -0700
If you have a reversible drill, there are left-hand drill bits available. By
drilling a pilot hole you can really get a grip in it with a larger
left-hand drill bit. ..bill
===============================================================
On Jun 28, 2008, at 1:51 PM, Dave G. wrote:

> My beast is a '65 Sprite.
> On the drivers side of the tunnel is/was a place for the seat belt  
> securing bolt.
> One of the DPO's has cut this bolt off (!) leaving less than 1/8"  
> of bolt
> showing... and then painted over it...
> I would like to solicit ideas on how to remove this sawn off bolt  
> so I can use the
> built in threaded part to install some proper seat belts...
> I have no power tools --- only hand tools.
_______________________________________________
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>