Actually Mike, it should match the clutch. Or rather, you need a 1275
thick plate for a 1275, so the clutch components and flywheel should
match. If they don't then you have to combine the right clutch parts.
3 different release bearing heights. 3 pressure plate heights, stuff like that.
Peter C.
--------------------
At 06:54 AM 3/4/2008, Mike/Donna Carpenter wrote:
>I know that you guys have probably answered this question a million
>times. However, I'm asking again.
>
>The engine back plate that you put on, is it supposed to match the
>engine as in thick for 1275, thin with bent edge for 948 and
>1098? Or is the engine back plate supposed to match the
>transmission that will be used?
>
>Why is there a difference and why must they be paired up?
>
>Thanks,
>
>Mike Carpenter
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|