Clutch disk needs to be centered vary carefully, There is a special tool but
it can be done without it.
----- Original Message -----
From: "Chris Manuel" <cmanuel@wi.rr.com>
To: "'Jack Laird'" <jlaird237@cox.net>; "'Spridget Mailing List'"
<spridgets@autox.team.net>
Sent: Tuesday, July 03, 2007 1:32 PM
Subject: RE: [Spridgets] Rib Case Gear box question AGAIN
>
> I never had them apart. I have no problem taking it off, but I have no
> idea
> how to align it back up if I do, even when reading the Bentley book. Is
> it
> tough?
>
> I had an old motorcycle that did this once, but figured this was a little
> more involved considering the rear end and all.
>
>
> -----Original Message-----
> From: Jack Laird [mailto:jlaird237@cox.net]
> Sent: Tuesday, July 03, 2007 1:22 PM
> To: Chris Manuel; 'Spridget Mailing List'
> Subject: Re: [Spridgets] Rib Case Gear box question AGAIN
>
> If you did not have the pressure plate off when the tranny was out the
> chances are preaty good.
>
>
> ----- Original Message -----
> From: "Chris Manuel" <cmanuel@wi.rr.com>
> To: "'Spridget Mailing List'" <spridgets@autox.team.net>
> Sent: Tuesday, July 03, 2007 12:01 PM
> Subject: [Spridgets] Rib Case Gear box question AGAIN
>
>
>> Hi all-
>>
>> So I finally got things to line up well. I think I uncovered another
>> problem though...what are the chances of the clutch plates stuck
>> together?
>>
>> If I spin the engine and move the clutch lever the tail shaft still
>> moves.
>>
>> Not really a good sign, right?
>>
>> Chris
>> 66 MKIII
>> Brookfield, WI
>>
>>
>>> Hi-
>
>
>
>
>
> --
> No virus found in this incoming message.
> Version: 7.5.476 / Virus Database: 269.9.14/880 - Release Date: 6/29/2007
> 2:15 PM
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|