As far as I know: 948/1098, 1275, 1500 with respective lengths of: 2.5",
3.0", & 3.25" and the Mini/Metro is 3.5% and can be used. A longer than
standard
pushrod or modified length pushrod is indicative of a worn carbon clutch
release bearing or a flywheel heavily refaced or maybe a worn clutch plate -
all
of which need that longer push.
Daniel1312 - still looking for buyers for crossflow rad silicone hose - to
get the tooling made........
In a message dated 09/09/06 14:50:54 GMT Daylight Time,
kristi74midget@comcast.net writes:
> Hey guys and gals,
> Lambert and I are trying to replace my slave cylinder for the
> clutch. We got the old one out and realized that we needed the push
> rod from the old one until we can get a new push rod. When we took
> it out of the old slave it is really gunked up so we are cleaning it
> up a little again until we can get a new one. My question is how
> long is the push rod supposed to be? We measured this one and it
> measure 3 and a half inches. Is this right or is it to long?
|