Mark,
The Moss Motors catalog does a good job on this. It takes a
little spatial figuring to make the leap from their diagram, but
there are several brands of bearing whose writing may be on the
thrust, or on the non-thrust side. Honest, the Moss book does a good
job on this.
Peter
==
At 10:44 AM 5/24/2006, you wrote:
>I am reassembling the front hubs on my Bugeye and need a confidence check on
>the bearing placement. As I recall from doing it 10 years ago the "Thrust"
>marking on the bearings are like this:
>
>The "Thrust" marking faces the center of the car on both bearings. Outer
>bearing "Thrust" side mates with the spacer and the inner bearing "Thrust"
>side mates with the grease seal. My bearings are marked so I don't have to
>try to figure that out.
>
>Please correct me if this isn't right.
>
>Mark
>Nashville
|