Hi Bob,
I just happen to have a Bugeye disk wheel axle assembly laying on the floor
of my garage - complete with handbrake rods. The short rod measures 14 1/2"
overall length and the long rod is 26 3/4". Hmmm....
Rick
'59 & '61 Sprites
----- Original Message -----
From <BCAH at aol.com>
To: <spridgets@autox.team.net>
Sent: Sunday, December 26, 2004 8:28 PM
Subject: wire wheel-bolt on wheel
> Since the two rear end assembles are different sizes,with different shaft
> lengths, then the hand brake rods have to be different lengths. This would
be
> easy to measure to identify which is which. I have the measurements
somewhere in
> my files but have never been able to check several cars. As bad as the DPO
> was, I believe my BI actually has the true wire wheel rear assembly.Anyone
with a
> known type care to measure theirs? OK, just found my notes.----overall
length
> (not hole center to hole center) is,----14 3/4 " for short rod, and
> -------26 1/2 " for long rod for wire wheel rear end. Would anyone have
these rods
> off so we could get hole to hole measurements? Bob C
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.298 / Virus Database: 265.6.4 - Release Date: 12/22/04
|