Since the two rear end assembles are different sizes,with different shaft
lengths, then the hand brake rods have to be different lengths. This would be
easy to measure to identify which is which. I have the measurements somewhere
in
my files but have never been able to check several cars. As bad as the DPO
was, I believe my BI actually has the true wire wheel rear assembly.Anyone with
a
known type care to measure theirs? OK, just found my notes.----overall length
(not hole center to hole center) is,----14 3/4 " for short rod, and
-------26 1/2 " for long rod for wire wheel rear end. Would anyone have these
rods
off so we could get hole to hole measurements? Bob C
|