HI.
I just did the rear brakes on my 68 Sprite. I used new external circlips and
the old thin washers I saved when the old cylinders were removed.
Very simple to install if you have snap ring pliers. Needle nose pliers
would probably work too.
The new cylinders had a paper gasket that I used as well, although I doubt
they have much usefulness.I took one look at the clips that came with the
new cylinders and knew they would be a pain to install, so I tossed them.
Hope this helps,
J
----- Original Message -----
From "bill b." <w_burrell at yahoo.com>
To: "midgetsprite group" <midgetsprite@yahoogroups.com>; "spridget list"
<spridgets@autox.team.net>
Sent: Monday, March 08, 2004 6:49 PM
Subject: Rear Brake Circlips
> Aaaaaargh. 1969 Sprite. Replacing both rear wheel
> cylinders. Is there some magic trick to getting the
|