To: | <spridgets@autox.team.net> |
---|---|
Subject: | thrust washer? |
Date: | Sat, 29 Nov 2003 21:00:29 -0500 |
Hi folks. I have a question about this 68 Sprite steering/suspension I'm working on. The shop manual shows a thrust washer between the shock trunnion and the swivel axle, but on disassembly there was none. No shims either. After a test fit of the cleaned parts I have over 1/16 inch vertical movement of the axle on the king pin. So, how much movement should I have and where can I get a thrust washer and shims? I suppose I could make one if I knew the correct thickness. Thanks, John |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | 1275 coil, Unknown |
---|---|
Next by Date: | Re: Out of Office AutoReply: Help - Anemic fuel pumps, Unknown |
Previous by Thread: | 1275 coil, Unknown |
Next by Thread: | Re: thrust washer?, Unknown |
Indexes: | [Date] [Thread] [Top] [All Lists] |