I need to remove the rear hub from my car and do not have tool 18G 146 as
specified in the manual. I guess I can use a bearing puller I have if I go
to the machine shop and get them to make a "plug" for the axle so I have
something for the puller to push against and go to the metal shop and get a
couple pieces of angle iron cut to connect the puller to the studs. This
sounds like a lot of running around and could get expensive. Is there a
better way?
Thanks
Sandy Brown
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|