I had the guy pull the both the header and the muffler system to check
just this connection. The header has 4 longitudinal cuts on the
collector end as if the clamp would go there, but not so. The exhaust
pipe connection end was expanded to soip over the collector. We
measured it and it was a nice tight fit. This is the advantage of
living 10 minutes away from APT.
Mike MacLean
60 Sprite
56 BN2
02 FLSTS
00 F-150
89 Nissan Sentra (Yuck!)
David Ramsey wrote:
>I hope they can send him a header and muffler that go together. The
>matched set they sent me had one size pipe on the headers and another on
>the exhaust pipe. They did take back the exhaust system and so the
>local steel muffler on my car. Hard to send back the jet-hot coated
>headers with the dent in the tube, I lost a lot of respect for APT on
>that deal.
> Crash
>
>Frank,
> I was at APT the other day and went in the back warehouse to check
>out the exhaust systems. The RC40 setup comes in several
>configurations. There is the traditional Mini setup, but there is also
>a single box setup configured for Sprites. It has hangers just like a
>stock setup and the single box muffler looks very much like the stock
>948 Sprite muffler.
>Mike MacLean
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive
|