Brad Fornal wrote:
>I think a .020 should do it, if they are still available. I tried to speak
>with David Anton at APT but he is very busy. Those on the list that pray,
>please think of him, I was told he is going back to England as his father
>just had a stroke. The person I spoke with says that APT doesn't offer any
>oversized cam bearings, so any other options would be welcomed
>Brad
>
>
>
Brad,
The .020 set were trashed when they were removed. I do have a set of
.005 if they will help. (and I may have a set of .010 if I dig around a
bit).
Can you have the block checked, maybe if you're lucky the .005 set will
work.
Numbers on the box;
Vandervell
VP-956 .005 / .125mm
Kevin
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|