I think a .020 should do it, if they are still available. I tried to speak
with David Anton at APT but he is very busy. Those on the list that pray,
please think of him, I was told he is going back to England as his father
just had a stroke. The person I spoke with says that APT doesn't offer any
oversized cam bearings, so any other options would be welcomed
Brad
"mgraziano@mindspring.com" wrote:
> could brad make use of the +20 bearings? or would he need a larger
> oversize? Brad, how much bigger do you think you'll need?
>
> Original Message:
> -----------------
> From: Kevin Valentine valntine@ptd.net
> Date: Tue, 05 Aug 2003 10:36:43 -0400
> To: macy@bbl.med.upenn.edu, toyman@digitex.net, spridgets@autox.team.net
> Subject: Re: Oversize Cam Bearings
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|