I have a Spanish casting Weber 45 DCOE and don't see much different about it.
What do they mean air bleed adjustment screws? Is this just a case of the
wrong terminology being used?
If the carb is pre-calibrated why mess with something?
Daniel
In a message dated 07/07/03 12:56:43 Pacific Daylight Time,
PilotRob@webtv.net writes:
> While I've got you here, do you happen to
> know anything about the "air bleed
> adjustment screw(s)" on the new Weber
> 45DCOE152 carbs supposedly originated
> in Spain?
>
> There is a Spridget kit (1275) sold by VB
> which uses this model "45" which comes
> with a 4" Cannon intake manifold that
> comes pre-calibrated for the stock 1275 motor and a fellow lister is
> inquiring as
> to which circuit these apply to and how
> they "figure in".
>
> Not having seen these before, I haven't
> a clue and nothing is mentioned in the books I have on the subject.
> Maybe it's
> time for a new book?! :)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|