If my memory serves me (and it probable is not) match the release bearing to
the clutch/motor and the slave push rod to the transmission and slave
cylinder to match the master.
Paul Van Wig
pvanwig@charter.net
-----Original Message-----
From owner-spridgets-mod at autox.team.net
[mailto:owner-spridgets-mod@autox.team.net]On Behalf Of Alex Volk
Sent: Tuesday, June 17, 2003 3:54 PM
To: spridgets@autox.team.net
Subject: release bearing
Hello all,
Can anyone tell me what would happen if you used a 1098 release bearing on a
1275 car?
What would the clutch act like? I am thinking that maybe I was sold the
wrong
release bearing for my car. They would fit the same but the 1275 one looks
deeper, like it would "throw out" more clutch.
Thanks for any help, I really want to get this thing fixed before winter
Alex
61 midget
60 bugeye
/// Send your messages to spridgets@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|